Applying Filters

You can apply different types of filters on sensor's incoming data.

Procedure

  1. Click Menu > Expert Mode .
  2. Enter the password copernic.
  3. Click Menu > Receivers.
  4. Right-click the IP address of the receiver at the bottom of the page, then click Configure Receiver.
  5. From the left side of the screen where the system is displayed, click a sensor, for example Trawl Explorer.
  6. In Sensor Options, click Configure next to Filter.
    A panel listing available filters appears. The filters displayed depend on the functions of the selected sensor.
  7. From the Standard tab, select filters for each function. See Types of Filters for details about the filters.
  8. To change the default threshold values for the filters, click Advanced.
    Functions are listed with their threshold values. Change them according to your need.