Back to support page

Maintenance and Troubleshooting
Read this section for troubleshooting and maintenance information.
- Charging the Sensor with the Dock
  Connect a sensor to one of the 4 charging connectors of the Dock to display its level of charge.
- Cleaning the Sensor
  You need to regularly clean the sensor for proper performance.
- Maintenance Checklist
  We recommend you to follow this maintenance schedule for better performance and to avoid any trouble with the equipment.
- Changing the Pull Cords Position
  You can change the pull cords position on the sensor between center-pull or side-pull.
- Replacing the Catch Magnet or Cords
  You can replace the magnet or cord that are part of the pull cord assembly when they are broken.
- Troubleshooting
  Learn how to solve common problems.
- Support Contact
  You can contact your local dealer if you need maintenance on your Marport products. You can also ask us at the following contact details:

Changing the Pull Cords Position

You can change the pull cords position on the sensor between center-pull or side-pull.

Procedure

Remove the screws on the pull cord assembly with a 9/64 size Allen key.
Remove the pull cord assembly and install it again on the endcap (center-pull) or the side of the housing (side-pull).
Apply anti-seize on the screw threads, then tighten the screws with the 9/64 size Allen key.