Back to support page

Home
System Configuration and Display
Learn how to configure the receiver and display the sensor data in Scala2 application.
Replaying Data Recorded on a SD Card
You can replay in Scala2 data that have been recorded in high definition on the SD card .

System Configuration and Display
Learn how to configure the receiver and display the sensor data in Scala2 application.
- Adding the Sensor to the Receiver
  You need to add the sensors to the receiver in order to display their data on Scala2.
- Configuring the System with the Positioning Option
  If the sensors have the positioning option, you need to configure the system in order to receive the trawl position and display it in Scala2.
- Configuring Data Display on Scala2
- Changing the Number of Trawls
  You need to remove specific clumps when reducing the number of trawls in water.
- Replaying Data Recorded on a SD Card
  You can replay in Scala2 data that have been recorded in high definition on the SD card .

Replaying Data Recorded on a SD Card

You can replay in Scala2 data that have been recorded in high definition on the SD card .

About this task

Note: Data in high definition is available only when downloading them from the sensor memory. Data received in Scala2 will have a lower definition.

Procedure

Download from Mosa2 the files recorded on the sensor memory.
Right-click the timeline and click Change Directory to choose the source directory where the files are stored.
In the replay bar, the recording period of the files in high definition is displayed in green.

In the control panels, data that were received in live are displayed in the Mx panel and data recorded on the SD card are displayed in the A2S Data panel.
Go to the control panels, then click and drag data from the A2S Data panel to a page.