Back to support page

Home
System Configuration and Display
Learn how to configure the receiver to be able to receive and display Speed sensor data.
Adding the Sensor to the Receiver
You need to add the sensor to the receiver in order to display its data on Scala2 software.

System Configuration and Display
Learn how to configure the receiver to be able to receive and display Speed sensor data.
- Adding the Sensor to the Receiver
  You need to add the sensor to the receiver in order to display its data on Scala2 software.
  - Adding the Sensor with a Configuration File
    You can add the sensor to the receiver with a configuration file that contains the sensor settings you configured on Mosa2.
  - Adding the Sensor Manually
    You can add the sensor to the receiver from Scala2, by entering the same settings as the ones in Mosa2.
- Configuring Sensor Display on Scala2
  You can display on pages in Scala2 measurements (e.g. speed, pitch and roll...) taken by the sensors.
- Outputting Scala2 Symmetry Data to Scantrol
  You can output across speed data from Scala2 to Scantrol iSYM application.

Adding the Sensor to the Receiver

You need to add the sensor to the receiver in order to display its data on Scala2 software.

Speed sensors are compatible with the following M3/M4/M5/M6 receiver and Scala2 versions:


Firmware	Receiver version	Scala version
3N1 V2	all	all
TE/TS	04.01.03 or later	all
TE/TS V3	04.02.28 or later	01.02.05 or later