Installation Principles

Angle of Attack

The angle of attack is the angle of the door in relation to the towing direction. This angle is important for the efficiency of the doors. It varies between trawl door models, so refer to manufacturer to know the exact angle. The angle is usually from 25° to 40°.

1. Angle of attack: 25-40° 2. Opening angle 25-40°

Opening and Elevation Angles

The opening and elevation angles depend on the pocket installation on the door.

The opening angle is the horizontal angle of the pocket in relation to the door. It should be between 25° and 40°. Opening angles should be in line with the angle of attack. You need to indicate the opening angle on Mosa2.

The elevation angle, or tilt angle, is the vertical angle of the pocket in relation to the door. It should be between 15° and 20°. The sensor must point toward the vessel: adjust the elevation angle based on the operational depth of the door during fishing operations.

1. Elevation angle: 15-20° 2. Opening angle: 25-40°

1. Elevation angle: 15-20°

Roll Angles

Roll angle of the sensors depends on the tilt of the doors when fishing. If doors are straight during fishing, you can apply a roll angle of 90°. If doors are tilted inward during fishing, slightly roll the pocket so that lines of communication between the sensors stay aligned. If not, you will have sporadic spread readings.

1. Adapt roll angles of pockets according to the tilt of the doors.

PRP & Digital Spread Communication

Spread sensors communicate with each other and with the receiver. Lines of communication between them and toward the receiver must be unobstructed.

The beamwidth toward the receiver (uplink ping) is 46° and beamwidth toward the other sensors (down ping) is 26°. This beamwidth is thinner: this is why it is important to keep sensors aligned.

		Communication toward receiver (46°)
		Communication between sensors (26°)
	Communication toward receiver (46°) Communication between sensors (26°) 1. Master sensor 2. Clump sensor 3. Starboard sensor

Slant Range sensors do not communicate with each other, so only lines of communication toward the hydrophones must be unobstructed.