Back to support page

Home
Useful Resources
Pocket Drawings
Drawings to manufacture Spread Sensor pockets to be placed on trawl doors. Ask your local Marport Office for scaled templates.

Useful Resources
- Frequency Plan
  It is important to carefully plan the setup of your sensors before adding them to the system. You can create a table with a list of frequencies and complete it when you add sensors.
- Compatible NMEA Sentences from Winch Control Systems, GPS and Compass Devices
  You can add to Scala2 measures coming from winch control systems that use the following NMEA sentences.
- Pocket Drawings
  Drawings to manufacture Spread Sensor pockets to be placed on trawl doors. Ask your local Marport Office for scaled templates.
- Example of Installation on Poly Jupiter Doors
- General Installation Instructions and Drawings
- Testing Relative Bearing Measurements
  You can test if the relative bearing measurements are correctly calculated by the door sensors.

Pocket Drawings

Drawings to manufacture Spread Sensor pockets to be placed on trawl doors. Ask your local Marport Office for scaled templates.