Configuring the Sensor Settings
You need to complete communication settings when you add the sensor to the receiver.
Important: Make sure the settings you enter here are the same
as in Mosa2.
1 | Sensor name displayed in Scala2 and its features. |
2 | Enter the same frequency as the one entered for the uplink frequency in Mosa2. |
3 | Click Configure to change filters
applied on incoming data. Filters are particularly useful to reduce interferences on the
echogram data. Note: Be aware that echogram filters
such as Echosounder and
Interference Reduction may remove small
targets on the echogram. Tip: Please refer to Scala2 user
guide for more information about the filters. |
4 | Select the same sounding direction, range, and detection threshold as those set in Mosa2. |
Click Apply when you have finished.