Installing the Dock on a Wall

Install the Dock on a wall, using the wall bracket delivered with it.

Before you begin

About this task

Tip: A template is printed on the product packaging. It will help you to drill the holes in the wall and align multiple Dock chargers, if necessary.

Procedure

  1. Mount the bracket to a wall with M6 screws.

  2. Slide the Dock in the bracket.

  3. Insert an M5 screw at the bottom of the bracket.

  4. You can use our magnetized wall support to hang the charger plug between uses. The support can be fixed to the wall using screws or using the adhesive tape on the back face.

    1. To fix the support with screws, use 4 to 4.5 mm screws.
    2. To fix with the adhesive tape: thoroughly clean and degrease the target surface with cleaning solvent, then dry it. Provide pressure for at least 30 sec. on the whole surface of the support using a hard edged plastic tool of the same size as the support. Wait for at least 6 hours before hanging the charger plug.
      Note: Do not bond the adhesive to a wooden surface.
      Note: Application is not recommended if the surface temperature is below 10°C (50°F) because the adhesive will become too firm to adhere readily. Ideal application temperature is 15.6°C (60°F) to 38°C (100°F). Heat can increase bond strength when bonding to metal parts.
    3. Place the charger plug pins facing up, as shown on the picture on the support.