Back to support page

Home
System Configuration and Display
Learn how to configure the receiver to be able to receive and display door sensor data.
Adding Sensors to the Receiver
You need to add the sensors to the receiver in order to display their data on Scala2.

System Configuration and Display
Learn how to configure the receiver to be able to receive and display door sensor data.
- Adding Sensors to the Receiver
  You need to add the sensors to the receiver in order to display their data on Scala2.
  - Adding the Sensor with a Configuration File
    You can add the sensor to the receiver with a configuration file that contains the sensor settings you configured on Mosa2.
  - Adding the Sensor Manually
    You can add the sensor to the receiver from Scala2, by entering the same settings as the ones in Mosa2.
- Configuring Data Display
  You can display measurements taken by the sensors (e.g. distances between doors, depth, pitch and roll...) on pages in Scala2.
- Receiving Warp Lengths from Scantrol
  You can output warp length data from Scantrol iSYM Trawl Control application to Scala2 software.

Adding Sensors to the Receiver

You need to add the sensors to the receiver in order to display their data on Scala2.


Firmware	Mx receiver version	Scala version
Spread Master/Slave V2	all	all
Spread Master/Slave V1	all	all
Door Sounder (FIRM124)	all	all
Door Sounder with target strength calibration (FIRM129)	04.02.28 or later	01.02.05 or later