Adding the Sensor to the Receiver

You need to add the sensors to the receiver using the system web page.

Procedure

1. From Scala2, click Menu > Expert Mode and enter the password copernic.
2. Right-click the IP address of the receiver at the bottom of the page, then click Configure Receiver.
3. From the left side of the receiver page, click Sensors.
   
   
4. From the page Add Sensor Product select:
   
   
   1. Product Category: Trawl Explorer
   2. Product Name: Trawl Navigator
   3. Trawl Gear Location: same as defined in Mosa2 (see Configuring the Trawl Node).