Connecting the Sensor to Mosa2

To configure the sensor, you need to connect it to Mosa2 application, using either the Dock or the Configuration Cable.

Using a Dock Charger Plug

About this task

Tip: Refer to Dock user manual to have more details about the use of this product.

Procedure

  1. Connect one Dock charging plug to the sensor's endcap.
  2. Mosa2 discovery page opens. The sensor is displayed.


    • Click to open the sensor configuration page.
    • Click to show the deploy animation on the charger plug for 30 seconds.

Using the Configuration Cable

Connect the Configuration Cable from the computer to the sensor to display the sensor configuration page on Mosa2.

About this task

Tip: Refer to the Configuration Cable Quick Reference Guide available on our website for more details about the use of this product.

Procedure

  1. Move other electrical devices minimum 1 m away from the computer.
  2. Connect the USB connector directly to the computer.
    Mosa2 opens automatically and the startup wizard is displayed. The LED on the plug is solid blue.
  3. Connect the three-pin plug to the sensor.
    The LED on the plug blinks alternatively blue and green.
  4. Wait a few seconds. The configuration page of the sensor is displayed on Mosa2.
    The LED on the plug is solid green.

Example



What to do next

You can now configure the sensor.
Note: You can keep the Configuration Cable continuously connected by USB, and virtually eject or connect it. When no sensor is connected to the Configuration Cable, click Menu > Eject Config Plug or Connect Config Plug. When ejected, you come back to the discovery page. It stays disconnected until you virtually connect to it or manually disconnect then connect it.