Learn how to configure the sensor settings.
You need to set these settings for Slant Range sensors.
To configure the sensor, you need to connect it to Mosa2 using a wireless communication or using the Configuration Cable.
You need to set these settings for Spread sensors.
You need to configure sounding settings for both Slant Range sensors.
You need to configure the settings of the signal sending positioning data.
You can increase the uplink power of the sensor to increase the power of the signal transmitted. It is useful if you have interferences or if the sensor is far from the vessel.
You can test the measures taken by the sensor (e.g. battery level, temperature, depth) to check that there are no faults.
You can export in a *.txt file all the settings configured for the sensor (such as ping length, frequency, range, TVG...).
You can export on an XML file the sensor settings that you configured on Mosa2. You can afterward use this file when adding the sensor to a receiver.
Back to support page