Learn how to configure the sensor settings.
You need to set these settings for Spread sensors.
To configure the sensor, you need to connect it to Mosa2 using a wireless communication or using the Configuration Cable.
You need to define for the Master Spread Sensor the type of trawl that you are using.
You need to define the type of Starboard and Clump (if applicable) sensors that are installed.
You need to configure telegrams sent by the Master, Starboard and Clump (if applicable) sensors.
You need to configure the settings of the signal sending positioning data.
For XL bottles produced before S/N 3636606 (see sticker on the end cap), you need to configure correctly the up and down channels.
You need to calibrate the pitch and roll of the sensors when they are placed in the sensor pockets.
You need to set these settings for Slant Range sensors.
You can increase the uplink power of the sensor to increase the power of the signal transmitted. It is useful if you have interferences or if the sensor is far from the vessel.
You can test the measures taken by the sensor (e.g. battery level, temperature, depth) to check that there are no faults.
You can export in a *.txt file all the settings configured for the sensor (such as ping length, frequency, range, TVG...).
You can export on an XML file the sensor settings that you configured on Mosa2. You can afterward use this file when adding the sensor to a receiver.
Back to support page