Back to support page

Home
System Configuration and Display
Learn how to configure the receiver to be able to receive and display catch sensor data.

System Configuration and Display
Learn how to configure the receiver to be able to receive and display catch sensor data.
- Adding the Sensor to the Receiver
  You need to add the sensor to the receiver in order to display its data on Scala2.
- Configuring Data Display
  You can display on pages in Scala2 measurements taken by the sensors (e.g. catch status, depth, pitch and roll...).

System Configuration and Display

Learn how to configure the receiver to be able to receive and display catch sensor data.

Note: This guide refers to the following versions of Scala2: 02.10.x. If you use another version, the visual interface and options may vary.