Back to support page

Home
System Configuration and Display
Learn how to configure the receiver to be able to receive and display catch sensor data.
Adding the Sensor to the Receiver
You need to add the sensor to the receiver in order to display its data on Scala2.

System Configuration and Display
Learn how to configure the receiver to be able to receive and display catch sensor data.
- Adding the Sensor to the Receiver
  You need to add the sensor to the receiver in order to display its data on Scala2.
  - Adding the Sensor with a Configuration File
    You can add the sensor to the receiver with a configuration file that contains the sensor settings you configured on Mosa2.
  - Adding the Sensor Manually
    You can add the sensor to the receiver from Scala2, by entering the same settings as the ones in Mosa2.
- Configuring Data Display
  You can display on pages in Scala2 measurements taken by the sensors (e.g. catch status, depth, pitch and roll...).

Adding the Sensor to the Receiver

You need to add the sensor to the receiver in order to display its data on Scala2.


Firmware	Receiver version	Scala version
Catch	all	all
TE/Catch V2	04.02.02 or later	01.00.04 or later
TE/Catch V3	04.02.28 or later	01.02.05 or later