Configuring the Trawl Node

You need to give a trawl node to the sensor. It is the number corresponding to the position of the sensor on the trawl.

About this task

The trawl nodes corresponding to the positions on the codend are the following:
Trawl number Node numbers
Trawl 1 1 to 6
Trawl 2 101 to 106
Trawl 3 201 to 206
Trawl 4 301 to 306
Trawl 5 601 to 606


Procedure

  1. Go to the Communications page, then click in Uplink.
  2. Enter a node according to the position of the sensor on the trawl.

    Important: Make sure to put the same number when adding the sensor to Scala2 receiver page. If not, change it accordingly.




  3. Click .