Back to support page

Home
System Configuration and Display
Learn how to configure the receiver to be able to receive and display Seine sensor data.
Adding the Sensor to the Receiver
You need to add Seine sensors to the receiver in order to display sensor data on Scala2.
Defining the Trawl Gear Type
You need to choose a purse seine as trawl gear to be able to add seine sensors.

System Configuration and Display
Learn how to configure the receiver to be able to receive and display Seine sensor data.
- Adding the Sensor to the Receiver
  You need to add Seine sensors to the receiver in order to display sensor data on Scala2.
  - Defining the Trawl Gear Type
    You need to choose a purse seine as trawl gear to be able to add seine sensors.
  - Adding the Sensor with a Configuration File
    You can add the sensor to the receiver with a configuration file that contains the sensor settings you configured on Mosa2.
  - Adding the Sensor Manually
    You can add the sensor to the receiver from Scala2, by entering the same settings as the ones in Mosa2.
- Configuring Data Display on Scala2
  You can display measurements of Seine sensors (e.g. depth, height, echogram...) on pages in Scala2.

Defining the Trawl Gear Type

You need to choose a purse seine as trawl gear to be able to add seine sensors.

About this task

Important: If you change the trawl gear type of an existing trawl, you will loose all settings you made for the sensors added to this trawl. You will have to add them back and create new pages.

Procedure

Click Menu > Expert Mode , and enter the password copernic.
Right-click the IP address of the receiver at the bottom of the page, then click Configure Receiver.
From the left side of the screen where the system is displayed, click Trawl Gear.
From the Trawl Gear List, select Port Seine Gear if you shoot your purse seine on the port side of the vessel or Starboard Seine Gear if you shoot it on the starboard side.

What to do next

You can add seine sensors to the system.