Back to support page

Home
Sensor Configuration
Learn how to configure the sensor settings.

Sensor Configuration
Learn how to configure the sensor settings.
- Connecting the Sensor to Mosa2
  To configure the sensor, you need to connect it to Mosa2 using a wireless communication or using the Configuration Cable.
- Speed Explorer Specific Settings
  Speed Explorer sensor has specific settings that need to be configured.
- Configuring Flow Sensor Telegrams
  You need to define channels and telegrams that the sensor uses to transmit data to the receiver. These settings are for Trawl Speed, Grid and Symmetry sensors.
- Checking Speed Measures with EM Log Tester
  You need to check the speed measures of all speed sensors with an EM Log tester.
- Configuring the Uplink Power
  You can increase the uplink power of the sensor to increase the power of the signal transmitted. It is useful if you have interferences or if the sensor is far from the vessel.
- Testing Measures
  You can test the measures taken by the sensor (e.g. battery level, temperature, depth) to check that there are no faults.
- Exporting Sensor Configuration Settings for Record Keeping
  You can export in a *.txt file all the settings configured for the sensor (such as ping length, frequency, range, TVG...).
- Exporting Sensor Configuration Settings for the Receiver
  You can export on an XML file the sensor settings that you configured on Mosa2. You can afterward use this file when adding the sensor to a receiver.

Sensor Configuration

Learn how to configure the sensor settings.

Note: This guide refers to the following versions of Mosa2: 02.11.x . If you use another version, the visual interface and options may vary.