Home
Sensor Configuration
Learn how to configure the sensor settings.
Testing Measures
You can test the measures taken by the sensor (e.g. battery level, temperature, depth) to check that there are no faults.

Sensor Configuration
Learn how to configure the sensor settings.
- Connecting the Sensor to Mosa2
  To configure the sensor, you need to connect it to Mosa2 application, using either the Dock or the Configuration Cable.
- Battery Information
- About the Virtual Water-Switch Option
  Mosa2 has a virtual water-switch option that changes the conditions under which the sensor is running.
- Diagnostic Information
  Scala2 and Mosa2 applications warn the user in case of water ingress in the sensor.
- Configuring Door Spread Settings
  Configure the communication settings between the spread sensors.
- Configuring the Trawl Node
  You need to give a trawl node to the sensor. It is the number corresponding to the position of the sensor on the trawl.
- Configuring the Uplink Frequency and Power
  Configure the settings of the communication link between the sensor and the vessel.
- Configuring Positioning Signal Settings
  Configure the following settings if the sensor has the positioning option.
- Configuring the Echo Sounder
  Configure the echo sounder settings of the Door Explorer.
- Calibrating the Pitch and Roll
  You need to calibrate the pitch and roll of the sensors when placed on the trawl doors.
- Applying Offsets to Measurements
  You can apply offsets to temperature and depth measurements if the measured values does not correspond to the environment of the sensor.
- Testing Measures
  You can test the measures taken by the sensor (e.g. battery level, temperature, depth) to check that there are no faults.
- SD Card Recording
  This topic explains the SD card recording feature (this feature is optional).
- Saving a Configuration on Mosa2
  You can save different configurations of the sensor to be able to quickly change the configuration when you change your fishing method.
- Exporting Sensor Configuration
  You can export the sensor settings you configured on Mosa2 on a file. You can afterward use this file when configuring a similar sensor.
- Importing a Sensor Configuration
  You can apply to a sensor a configuration that has already been made on another sensor.

Testing Measures

You can test the measures taken by the sensor (e.g. battery level, temperature, depth) to check that there are no faults.

About this task

You can test the sensor in water or in air. In air, the following measures will be wrong: height, conductivity.

Procedure

Press command + A or click Menu and click User Mode > Advanced
Go to the Monitoring page.
You can check information about the battery, board and sensor.
Go to the Measurements page.
You can see the values of the activated measures, such as depth, temperature. If the sensor is working correctly, measures are updating.
Click to check and, if necessary, adjust data measured by the sensor:
- Depth: Place your sensor on a desk or on the ground and enter 0 in Target Depth.
- Temperature: Enter the estimated temperature of your environment.
- Motion: Calibrate the door sensors.