Adding the Sensor to the Receiver
You need to add the sensors to the receiver using the system web page.
Procedure
- From Scala2, click and enter the password copernic.
- Right-click the IP address of the receiver at the bottom of the page, then click Configure Receiver.
-
From the left side of the receiver page, click Sensors.
-
From the page Add Sensor Product select
the options according to your type of sensor:
Product Category Product Name Trawl Gear Location Spread Master Door Explorer Pro Master 23 Door Explorer Master Spread Starboard Door Explorer Pro Starboard - Single trawl: 26
- Twin trawls: 123
- Triple trawls: 223
- Quadruple trawls: 323
Door Explorer Starboard Spread Clump Door Explorer Pro Clump - Twin trawls: 26
- Triple trawls: 26, 123
- Quadruple trawls: 26, 123, 223