Back to support page

Home
System Configuration and Display
Learn how to configure the receiver to be able to receive and display HDTE sensor data.
Adding the Sensor to the Receiver
In order to display HDTE sensor data, you need to add it to the receiver.
Adding the Sensor Manually
You can add the sensor to the receiver from Scala2, by entering the same settings as the ones in Mosa2.
Adding the Sensor to the Receiver

System Configuration and Display
Learn how to configure the receiver to be able to receive and display HDTE sensor data.
- Adding the Sensor to the Receiver
  In order to display HDTE sensor data, you need to add it to the receiver.
  - Adding the Sensor with a Configuration File
    You can add the sensor to the receiver with a configuration file that contains the sensor settings you configured on Mosa2.
  - Adding the Sensor Manually
    You can add the sensor to the receiver from Scala2, by entering the same settings as the ones in Mosa2.
    - Adding the Sensor to the Receiver
    - Configuring the Sensor Settings
- Configuring Sensor Data Display on Scala2
  You can display HDTE incoming data (e.g. echogram, depth, temperature,...) on pages in Scala2. You can also display target strength data, that help you differentiate sizes and species of fish.

Adding the Sensor to the Receiver

About this task

In order to avoid differences of settings between the configuration you made on Mosa2 and the one on Scala2, we recommend you to rather add the sensor to the receiver with an XML configuration file exported from Mosa2.

Procedure

From Scala2, click menu > Expert Mode and enter the password copernic.
Click menu again, then Receivers.
From the left side of the receiver page, click Sensors.
From Product Category, select Trawl Explorer.
From Product Name, select Narrow Band High Definition Trawl Explorer (HDTE).
From Trawl Gear Location, select the location of the sensor on the trawl. Sensor locations are called nodes and have a numerical value between 1 and 999. We recommend you to choose: 7, 8 or 9 for a mounting on the tunnel, and 10, 11, 12 or 13 for a mounting on the headrope.

Note: If you defined a node in Mosa2, be careful to keep the same node number.
Click Add Sensor.
The sensor is added to the receiver and displayed on the left side of the screen. The configuration page is displayed.