Home
Sensor Configuration
Learn how to configure the sensor settings.
Diagnostic Information
Scala2 and Mosa2 applications warn the user in case of water ingress in the sensor.

Sensor Configuration
Learn how to configure the sensor settings.
- Connecting the Sensor to Mosa2
  To configure the sensor, you need to connect it to Mosa2 application, using either the Dock or the Configuration Cable.
- Battery Information
- About the Virtual Water Switch Option
  Mosa2 has a virtual water switch option that changes the conditions under which the sensor is running.
- Diagnostic Information
  Scala2 and Mosa2 applications warn the user in case of water ingress in the sensor.
- Configuring the Trawl Node
  You need to give a trawl node to the sensor. It is the number corresponding to the position of the sensor on the trawl.
- Configuring the Uplink Frequency and Power
  Configure the settings of the communication link between the sensor and the vessel.
- Configuring the Echo Sounder
  Configure the echo sounder settings of the Trawl Navigator.
- About the Automatic Range Mode
  The sensor has an automatic range mode that is useful to get better quality echograms when the trawl is close to the bottom.
- Applying Offsets to Measurements
  You can apply offsets to temperature and depth measurements if the measured values do not correspond to the environment of the sensor.
- Testing Measures
  You can test the measures taken by the sensor (e.g. battery level, temperature, depth) to check that there are no faults.
- Memory Card Recording
  This topic explains the memory card recording feature (this feature is optional).
- Saving a Configuration on Mosa2
  You can save different configurations of the sensor to be able to quickly change the configuration when you change your fishing method.
- Exporting Sensor Configuration
  You can export the sensor settings you configured on Mosa2 on a file. You can afterward use this file when configuring a similar sensor.
- Importing a Sensor Configuration
  You can apply to a sensor a configuration that has already been made on another sensor.

Diagnostic Information

Scala2 and Mosa2 applications warn the user in case of water ingress in the sensor.

Note: Diagnostic information is available for Marport Pro sensors (A2S and A2H PCBA versions), from the firmware version F450-02.02.00 or later and Mosa2 version 02.11.08.

In case of water ingress in the sensor, alarms are displayed in Scala2 Virtual Charger Room, in Mosa2 and on the charger plug when connected to the sensor.

In Expert mode, Mosa2 displays a dialog at the start of the application and warning icon in the toolbar and diagnostic page:
The charger plug displays a warning icon:

When the alarm appears, take the sensor out of water immediately and contact Marport support.

Warning: In case of water ingress in the product, do not charge it: battery may vent or rupture, causing product or physical damage.