Data in Scala2 is wrong

Data displayed in Scala2 is wrong.

There are signal interferences.
  1. First, check that the sensor frequencies and telegrams are the same in the sensor configuration (via Mosa2) and the receiver configuration (via Scala2 or the system web page).
  2. Check the frequencies of your other sensors and make sure there is enough distance between them.
  3. Check the noise on the spectrum (see Checking Noise Interference). If the frequency where the sensor is placed is too noisy, change for a less noisy frequency:
    1. Spread Sensor: see Configuring Spread Sensor Telegrams
    2. Slant Range: see Configuring Sounding Frequencies
    Important: Do not forget to also change the frequency on the system web page (accessible through Scala2 receiver page).
  4. You can increase the uplink power of the sensor to increase the power of the signal transmitted to the receiver: see Configuring the Uplink Power.