Slant Range: Slant distance is too long

The slant distance displayed in Scala2 is longer than the distance indicated by the winch control system.

Slant distance is calculated from the distance between the sensor and the receiving hydrophone. If the hydrophone is placed further away from the stern than the winch control system, it will display a longer distance. You need to apply an offset to the slant distance.
  1. From Scala2, click Menu > Expert Mode and enter the password copernic.
  2. Right-click the IP address of the receiver at the bottom of the page, then click Configure Receiver.
  3. From the left side of the screen, click the name of your sensor.
  4. From Sensor Options > Slant Range > Filter, click Configure.
  5. From Distance Filter, apply an offset corresponding to the difference between what displays the winch control system and the Slant Range sensor.