Back to support page

Home
System Configuration and Display
Learn how to configure the receiver and display the sensor data in Scala2 application.
Adding the Sensor to the Receiver
You need to add the sensors to the receiver in order to display their data on Scala2.
Adding the Sensor to the Receiver
You need to add the sensors to the receiver using the system web page.

System Configuration and Display
Learn how to configure the receiver and display the sensor data in Scala2 application.
- Adding the Sensor to the Receiver
  You need to add the sensors to the receiver in order to display their data on Scala2.
  - Adding the Sensor to the Receiver
    You need to add the sensors to the receiver using the system web page.
  - Configuring Sensor Settings
    You need to complete communication settings when you add the sensor to the receiver.
- Configuring Data Display on Scala2
  You can display the sensor's measurements and echograms on Scala2 pages.
- Displaying the Trident View
  Trident sensors have a dedicated 3D view, showing the echogram beams, the sounding range, the depth and roll values of the sensor.
- Replaying Data Recorded on a SD Card
  You can replay data that have been recorded in high definition on the SD card .

Adding the Sensor to the Receiver

You need to add the sensors to the receiver using the system web page.

About this task

Important: To be able to add the Trident sensor to the receiver, the version of the receiver firmware must be 08.01.01 and above.

Procedure

From Scala2, click Menu > Expert Mode and enter the password copernic.
Right-click the IP address of the receiver at the bottom of the page, then click Configure Receiver.
From the left side of the receiver page, click Sensors.
From the page Add Sensor Product select:
1. Product Category: Trawl Explorer
2. Product Name: Trident Down Looking or Trident Up Looking.
3. Trawl Gear Location: same as defined in Mosa2 (see Configuring the Trawl Node).