Back to support page
Adding the Sensor to the Receiver
You need to add the sensors to the receiver using the system web page.
About this task
Important: To be able to add your sensor to the receiver, make sure your
receiver version is compatible. Check System Compatibility.
Note: Marport systems are limited to a fixed number of
channels, and the sensors use a specific number of channels based on the type of
data they send. The Trident uses 1
sounder channel, then one PPM channel per measure (e.g. depth,
temperature,…).
Procedure
-
From Scala2, click Menu
> Expert Mode and enter the password copernic.
- Right-click the IP address of the receiver at the bottom of the page, then click Configure Receiver.
-
From the left side of the receiver page, click Sensors.
-
From the page Add Sensor Product, select
the options corresponding to your type of sensor:
- Product Category: Trawl Explorer
- Product Name: Trident Down Looking or Trident Up Looking.
- Trawl Gear Location: same as defined in Mosa2 (see Configuring the Trawl Node).
-
Click Add Sensor.
The sensor is added to the receiver and displayed on the left side of the screen. The configuration page is displayed.