Back to support page

Home
Sensor Charging and Configuration
Learn how to use the Dock to charge and configure the sensors.
Charger Plug Status Summary

Sensor Charging and Configuration
Learn how to use the Dock to charge and configure the sensors.
- Overview of the Dock Screen
  The Dock displays the following information when the latest generation of sensors are connected. If previous generation sensors are connected, the screen only displays the level of charge.
- Charger Plug Status Summary
- LED Strip Status Summary
  A LED strip located above the charger connectors lights up according to the status of the sensor when the charger is connected.
- Charging a Sensor
  Connect a sensor to one of the 4 charging connectors of the Dock to display its level of charge.
- Using the Virtual Charger Room
  You can configure the latest generation of sensors from Scala2 Virtual Charger Room when they are connected to the Dock.
- Interface with Mosa2

Charger Plug Status Summary


Charger plug animation	Description
	Green: charged at > 90 %
	Orange: charged at 70 to 90 %
	Red: charged at < 70 %
	"Pick me up": displayed when triggered from the Virtual Charger Room.
	Configuring: sensor is being configured from Mosa2.
	Updating: sensor firmware is being upgraded from Mosa2.
	Caution: maintenance required. A message is displayed on the Dock screen. See Warning Messages for details.
	Warning: a message is displayed on the Dock screen. See Warning Messages for details.