Using the Virtual Charger Room

Main page

To open the Virtual Charger Room, click Menu > Virtual Charger Room on the top left corner of the screen.

Each sensor that is part of the fleet appears on a tile. The tiles are placed according to the sensor location on the trawl, depending on the configuration that was made in the system configuration page.

To fit the view according to the width of the tiles click , or click to fit according the height.

When a sensor that has not been added to the system is connected to the Dock, it is displayed underneath the other sensors (1). Only the charging status appears. A notification (2) also warns the user that the sensor is not part of the system configuration. When disconnected, the sensor is not displayed anymore.

Sensor status

	1. Node identifying the location of the sensor on the trawl.
	2. Name of the application
	3. If any, number of spare sensors. Click to show the other spare sensors.
	4. Charging level
	5. Access to the settings.
	6. Remaining lifetime at the current state of charge.
	7. Sensor status

The sensor is connected to the Dock and charging. It displays Ready to deploy when fully charged. Click > to display the "Pick me up" animation on the charger plug when the sensor must be deployed.	The sensor is operating on the trawl.	The sensor is out of water and is not connected to the Dock.

Notifications

When a sensor is connected to the Dock, the Virtual Charger Room is able to detect discrepancies between the system configuration and the sensor configuration. Notifications appear at the bottom of the page if the connected sensor is not part of the system configuration or if the sensor settings do not match the settings set in the system (based on the node).