Back to support page

Home
Sensor Charging and Configuration
Learn how to use the Dock to charge and configure the sensors.
Interface with Mosa2
Dock Page

Sensor Charging and Configuration
Learn how to use the Dock to charge and configure the sensors.
- Overview of the Dock Screen
  The Dock displays the following information when the latest generation of sensors are connected. If previous generation sensors are connected, the screen only displays the level of charge.
- Charger Plug Status Summary
- LED Strip Status Summary
  A LED strip located above the charger connectors lights up according to the status of the sensor when the charger is connected.
- Charging a Sensor
  Connect a sensor to one of the 4 charging connectors of the Dock to display its level of charge.
- Using the Virtual Charger Room
  You can configure the latest generation of sensors from Scala2 Virtual Charger Room when they are connected to the Dock.
- Interface with Mosa2
  - Mosa2 Discovery page
  - Dock Page
  - Connecting the Sensor to Mosa2 via the Dock
    Connect the sensor to Mosa2 when it is charging or by connecting a Configuration Cable to the Dock.

Dock Page

This page displays the state (application, bootloader, demo), board ID and firmware version of the Dock.

You can upgrade the Dock from this page: click Menu

> Upgrade Firmware and follow the wizard instructions.

Note: You need a .DCF file, available on Marport Authorized Service Provider (MASP).